AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Used jdm engine inc reviews1/7/2024 Now running Dynopro ATM mud and snow tires Michelin tires LTX, ( that last 100,000 miles) Joined: Member: #113940 Messages: 10,180 Gender: Male First Name: John Denver Vehicle: 97 reg cab, v6 5sp 300hp supercharged, Methonal Injection, 750,001 plus miles, Original Owner V6 5sp,RegCab,TRD Supercharger, 1.9” pulley, methanol injectedĢ004 DESNO fuel injectors, zero ping ping, Pictures of the heads and lower end are listed below. It had too much grime build up for it to have been removed in the past 10 years. Though, I did not see any evidence of the oil pan being removed in the past 100,000 miles. The rod bearings do not look like they have 226,000 miles. I can see where the previous owner replaced the heads. In looking over the current engine, I suspect it was damaged from severe overheating. What else should I consider before jumping into this project? Though, from what I see, I prefer the filter JDM location if it will work. The oil filter will be relocated from the JDM location. I have not seen outlets for those hoses on JDM engine pictures. The current hoses do not appear to go anywhere. I noticed the current engine has two hoses that route through the short block on the oil filter side. I think I will benefit from the JDM engine's A/C compressor, alternator, and PS pump. The current intake will be moved to the new engine.ħ) Sensors will be moved and most likely replaced.Ĩ) Injectors will be sent for cleaning and flow rate testing. If they are not perfect, they will be replaced.Ħ) I will install new throttle body, intake and exhaust manifold gaskets. I will run a leak down compression test to look for bad rings or valves.ģ) Front and rear main seals and any rubber hoses, VC grommets, and related gaskets will be replaced.Ĥ) The timing belt, water pump, and any related wear items will be replaced with new.ĥ) Rod and main bearings will be removed and inspected. If something goes wrong and I need to return it, I know people in Memphis who will tell me where they live.Ģ) When the engine is delivered, I will put it on an engine stand in the garage and go to work. Using this seller will knock $100 off the shipping cost. Click to expand.1) There is a JDM seller in Memphis that I would use.
0 Comments
Read More
Leave a Reply. |